Cypress COH-Tx1 Kullanım Kılavuzu - Sayfa 8

Alıcı Cypress COH-Tx1 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cypress COH-Tx1 12 sayfaları. Hdmi to optical transmitter and receiver

Sayfayı Yazdır

7.2 Receiver

Front Panel

HDMI

Error

Output

Optical

HDMI

① ③ ②

① Optical LED: This LED will illuminate in blue when at least one optical cable

is connected and has successfully detected and communicated

between Tx & Rx with video or audio data sending. If the LED is not

illuminate users need to check the connection of the fiber cable and

then make sure the connection is well and the cable itself is good.

② Error LED: Normally this red LED will not illuminate but only blinks for few

seconds when startup the device. When the LED is illuminated constantly,

it means the output HDMI is not able to output HDMI signal. Therefore,

please double check the connection and also make sure the source is

sending correct HDMI signal

Check the connections and make sure they are all connected well.

③ HDMI LED: This LED will illuminate in blue, when the device is communicate

with the display.

④ HDMI Output: This slot is to connect with output display such as an HDTV or

monitor with HDMI cable.

⑤ IR-In: This slot is to connect with the IR extender included in the package

for IR signal receiving from the display side to send to the sourc equipment

and control it.

⑥ RS-232: This slot is to connect with 3.5Ø phone jack to D-Sub 9pin

converter adaptor included in the package for RS-232 control and signal

sending.

⑦ Optical SUB & Main: These slots are to connect with the optical 2 ways

cable from the transmitter side up to 300 meters.

Note: Connector Type: LC-LC, Fiber: Duplex Single-mode Fiber

⑧ DC 5V: This slot is to connect with the power adaptor included in the

package from the AC wall outlet for power supply.

IR-In RS-232

④

⑤

⑥

Rear Panel

Optical

SUB

DC 5V

Main

⑦

⑧