Dolphin DOLKWP300318 Kullanıcı Kılavuzu - Sayfa 2
Tuş takımı Dolphin DOLKWP300318 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dolphin DOLKWP300318 4 sayfaları. Dual frequency 300/318 mhz keypad
Ayrıca Dolphin DOLKWP300318 için: Manuel (8 sayfalar)
Sayfayı Yazdır
STEP 1:
Set Jumper S1
Determine the operating frequency you
will use on your keypad installation. This
keypad can operate at either 300 MHz
or 318 MHz. At 300 MHz the keypad is
compatible with all 300 MHz receivers
with 10 dip switches. At 318 MHz the
keypad is compatible all 318 MHz
receivers with 9 dip switches.
(see Figure 1)
Figure 1
S1
jumper
in place
S1
STEP 2:
Set Jumper 4 on S2
• 300 MHz (10 dip switches) - Jumper set to OFF (in the DOWN position)
ON
S2
1 2 3 4
• 318 MHz (9 trinary dip switches) - Jumper set to ON (in the UP position)
ON
S2
1 2 3 4
STEP 3:
Set the DIP switches to match the Receiver
Set the DIP switches of the keypad to "+" for ON or CLOSE, and "-" for OFF or
OPEN. Note: Do not use the center position.
STEP 4:
Programming the Master Code
1. Press
*
2. Enter the "Master Code" (default is
3. Press the
*
4. Enter
1
for change code
0 0
5. Enter
for "Master Code"
6. Enter the new "Master Code" (Must be 4 digits)
7. Press the
button. The multi-color status LED flashes Green 3 times meaning
*
the code is accepted. If the multi-color status LED flashes 3 times Red, the
steps need to be repeated.
300 MHz
318 MHz
DIP
300 MHz
(10 dip switch)
10
button
S1
GND
1
2
3
4
)
ON
1
4 Sec
2
2 Sec
3
1 Sec
4
3 State/9 PORT 2 State/10 PORT
S2 Function Config
S1 Frequency Selection
ON
1 2 3 4
CON1
GND
OP
VIN
DIP
318 MHz
(9 dip switch)
10
not used
OFF
S2