Asian Resources Int'l Limited MHG-T2 Kullanım ve Bakım Talimatları Kılavuzu - Sayfa 15

İnvertör Asian Resources Int'l Limited MHG-T2 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları Kılavuzu indirin. Asian Resources Int'l Limited MHG-T2 18 sayfaları. Micro-hydroelectric generator

Sayfayı Yazdır

a) Start the generator and adjust the spear valve to obtain 220-240 volts, 0 amps at the

panel. [Do not turn the circuit breaker on].

b) Adjust the potentiometer on the circuit board very slowly to the left. When you

detect a small decrease in voltage, stop. Turn on the circuit breaker and increase water

to increase power to the unit. Increase power until a load of 2kW is indicated (P =VI).

c) If adjusting the potentiometer does not correct the problem, then contact PowerPal.

The problem is probably with the potentiometer.

TECHNICAL SPECIFICATIONS

1 Rated power output

2 Maximum allowable load

3 Intended voltage

4 Frequency at rated power output

5 Frequency at runaway speed

6 Runaway speed

7 Height

8 Weight

9 Turbine runner type

10 Runner diameter

11 Number of buckets

12 Number of nozzles

13 Generator

14 Generator insulation

15 Protection grade

16 Load controller circuit breaker

17 Upper generator bearing size

Lower generator bearing size

Turbine bearing size

18 Seal size

19 Recommended cable

20 Operating temperature

21 Operating humidity

Notes:

1,2.

Rated power output is the manufacturer's specified output for the given head

and flow conditions. A higher output is possible if the head is greater or the flow is

faster than recommended. If the maximum allowable load is exceeded then permanent

damage to the stator may occur.

Is approximately 220V when the ELC is used.

5,6.

Runaway speed is the speed of the rotor if no load is applied. This speed is

reduced under load.

18.

We recommend SKF brand or similar high quality bearings.

Also, the diagrams and much useful information on pages 7 and 16 are taken from

Micro-hydropower Sourcebook – A Practical Guide to Design and Implementation in

Developing Countries. NRECA, 1986.

MHG-T2

2000W

2200W

220V~

50 Hz

70 Hz

1500rpm

600mm

90kg

Turgo

270mm

3- phase

Class B

IP54

20A

6206-2Z

SKF 7206B

SKF 1207

38x58x10mm

4mm2

5 to 50 ° C

0 to 90%

PowerPal™ T2 Turgo 15