AsiaRF AW7915-NP1 Manuel - Sayfa 10

Kontrol Ünitesi AsiaRF AW7915-NP1 için çevrimiçi göz atın veya pdf Manuel indirin. AsiaRF AW7915-NP1 11 sayfaları.

Sayfayı Yazdır

5150-5850MHz

2400-2483.5MH

5150-5850MHz

2400-2483.5MH

5150-5850MHz

2400-2483.5MH

5150-5850MHz

2400-2483.5MH

5150-5850MHz

2400-2483.5MH

5150-5850MHz

4. Label and compliance information

Label of the end product:

FCC

The host product must be labeled in a visible area with the following " Contains FCC ID:

TKZAW7915NP1".

The end product shall bear the following 15.19 statement: This device complies with part 15 of the

FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

ISED

This transmitter module is authorized only for use in device where the antenna may be installed such

that

cm may be maintained between the antenna and users. The final end product must be labeled

in a visible area with the following: "Contains transmitter module IC: 9968A-AW7915NP1" or

"Contains IC: 9968A-AW7915NP1"

Contient le module d'émission IC: 9968A-AW7915NP1

The Host Model Number (HMN) must be indicated at any location on the exterior of the end product

or product packaging or product literature which shall be available with the end product or online.

5. Information on test modes and additional testing requirements

This module has been approved under stand-alone configuration.

OEM integrator has be limited the operation channels in channel 1-11 for 2.4GHz band.

The separate approval is required for all other operating configurations, including portable

configurations with respect to Part 2.1093/RSS-102 and different antenna configurations.

The information on how to configure test modes for host product evaluation for different operational

conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously

transmitting modules or other transmitters in a host can be found at KDB Publication 996369 D04.

OEM integrator is still responsible for testing their end product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC peripheral

requirements, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC/ISED authorization is no longer

considered valid and the FCC/IC No. cannot be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC/ISED authorization.

1F, 7, Houde Street, Younghe District, New Taipei City, Taiwan, R.O.C

ANT003

A245005N

A2405N

A5005N

A245004

A245002

2.4GHz: 2.5

PCB

5GHz: 2.5

2.4GHz: 4

PCB

5GHz: 5.1

PCB

2.4GHz: 5.2

PCB

5GHz: 5

2.4GHz: 4

Dipole

5GHz: 5.1

2.4GHz: 2

Dipole

5GHz: 2

www.asiarf.com

TEL: +886-2-29407880

FAX: +886-2-29407800

0.3dBi