Cyrus dAD1 Kullanıcı Talimatları - Sayfa 6

CD Çalar Cyrus dAD1 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Cyrus dAD1 13 sayfaları.

Sayfayı Yazdır
Cyrus dAD1
CONNECTING POWER TO THE UNIT
In the UK, the dAD1 comes fitted with a mains plug. The
plug fuse should be replaced only with a 3 Amp Fuse.
CONNECTING TO THE SYSTEM AMPLIFIER
Connect one end of a quality RCA interconnect to the
audio output sockets c on the rear panel of the dAD1 and
the other end to a line level input of your amplifier. Inputs
that are suitable for this purpose are CD or AUX. DO
NOT connect the dAD1 to the PHONO input.
CONNECTING AN EXTERNAL D/A CONVERTER
The dAD1 has a digital output signal, which may be used
to drive an external D/A converter. Using a 'digital'
phono interconnect, connect the socket marked DIGITAL
OUT d on the rear panel of the dAD1 to the input of a
suitable D/A converter. Referring to the relevant
handbooks, connect the audio outputs of the D/A
converter to a suitable input of the amplifier.
MC-BUS SYSTEM CONNECTION
Connecting the MC-BUS sockets on the rear panel enables
specific Cyrus products to operate as a fully functional
integrated system with your dAD1. The Additional
Information section of this manual has fuller details.
5
INSTALLATION & OPERATION
POWER CONTROL
The mains power to the dAD1 should normally be left on
unless left unattended for a long period when the mains
power at the wall socket should be switched off or the
product disconnected from the AC supply.
Please refer now to the front view on page 4
When power is applied to the dAD1, the STANDBY key
c can be used to switch the unit on and off. The standby
light d will show red when the Cyrus dAD1 is in standby
and green when operating.
LOADING A DISC
Press the STOP/OPEN key g to open the CD tray.
Load a CD into the tray with the label side upward.
Press the STOP/OPEN key to close the CD tray.
Note:- The dAD1 is designed for reproduction of audio
compact discs only. Do not attempt to play CD-ROM or
other types of disc on this product.
PLAYING A DISC
To play a disc, press the PLAY/PAUSE key 1@. Playback
of a disc will always commence from track 1 unless
otherwise selected. Refer to the front panel display on
page 6 for full details of the display information available
during disc playback.
English