cytiva 56-4106-11 Kullanım Kılavuzu - Sayfa 9

Laboratuvar Ekipmanları cytiva 56-4106-11 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. cytiva 56-4106-11 20 sayfaları. Midjet pressure display unit

Sayfayı Yazdır

Temperature

Figure 3.1: Typical transducer placement in a cross-flow system

Installing the transducers

Connect pressure transducers to the feed, retentate, and one of the permeate ports of your cross-

flow cartridge. Connect the transducer signal cables to the appropriate jacks—Inlet (or feed), Outlet

(or retentate and Permeate—on the back of the display unit. Plug the temperature sensor signal

cable into the jack on the back of the display unit. Place the temperature probe in the feed reservoir,

permeate collection vessel, or integrate it into the retentate line using a tee adaptor andLuer-Lok

connectors.

MidJet pressure display unit Instructions for use 18117465 AD

Tubing Pinch

Retentate

Clamp

Probe

Feed

Reservoir

Feed

Pump

CAUTION

The pressure display unit is calibrated at the factory with the

installed transducers. If you swap the transducers by plugging

them into different terminals on the back of the pressure display

unit, the accuracy of the pressure reading will be compromised. To

maintain the accuracy of the pressure display unit, do not swap the

transducers by plugging them into different terminals on the back

of the pressure display unit. Recalibrate the pressure display unit

when you install new pressure transducers.

Cross-Flow

Cartridge

Permeate Port

Blanked Off

Transducer

Pressure Display Unit

3 Setup and operation

Permeate

Line

Permeate

Collection

Vessel

Signal

Cable