EFX-TEK EZ-3micro 3.1 Hızlı Başlangıç Kılavuzu - Sayfa 4
Zamanlayıcı EFX-TEK EZ-3micro 3.1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. EFX-TEK EZ-3micro 3.1 5 sayfaları. Stage timer
Sayfayı Yazdır
Configuration
The EZ-3u is ready-to-run; simply connect a suitable trigger and desired outputs, then set the PRE, RUN, and
OFF stage potentiometers as required for the prop or display. Another feature of the EZ-3u that sets it apart
from similar controllers is the ability to configure the timing span for each potentiometer, as well as the pulse
output timing.
IMPORTANT: Disconnect any devices controlled by the Pulse or Audio outputs before entering the
configuration mode.
•
Power up (position 1) with configuration jumper installed; wait for flashing PRE LED.
•
While PRE LED is flashing, set PRE pot to desired zone. Press START to set
•
While RUN LED is flashing, set RUN pot to desired zone. Press START to set.
•
While OFF LED is flashing, set OFF pot to desired zone. Press START to set.
•
While PULSE LED is flashing, set RUN* pot to desired zone. Press START to set.
•
When all LEDs flash, your settings are saved. Power down and remove configuration jumper.
* Note: Setting the Pulse timing uses the RUN pot.
PRE Delay
RUN Time
OFF Time
PULSE / Audio
Values in parenthesis ( ) denote factory settings for PRE, RUN, OFF, and PULSE timing
4
Zone A
Zone B
( 0-10s )
0-20s
10-30s
( 10s-1m )
10-30s
( 10s-1m )
( 0.25s )
0.50s
Zone C
Zone D
0-30s
5-15s Random
10s-2m
10s-3m
10s-2m
10s-3m
1.00s
2.50s
EFX-TEK ● www.efx-tek.com ● [email protected]
Zone E
10-30s Random
10s-5m
10s-5m
5.00s