EG Vienna 250 EX Kullanıcı El Kitabı - Sayfa 4

Bisiklet EG Vienna 250 EX için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. EG Vienna 250 EX 8 sayfaları. Folding electric bicycle

2b. Power Assist Mode "E" (Economy mode) –

 Place the key in the lock/switch and turn the key clockwise to the right most position.

 Place the operation switch to the left of the handle bar in "E" position, and then ride

the bicycle normally as you would any bicycle.

 In this mode, the motor will assist you with a moderate amount of power as you pedal

the bicycle.

 The motor will stop when you stop peddling in this mode.

 This mode saves maximum amount of battery power.

 This mode will also give you the most miles per charge.

3. Fully Electric Mode –

 Place the key in the lock/switch and turn the key clockwise to the right most position.

 Install the optional throttle grips (included)

 Place the operation switch to the left of the handle bar in any position you desire.

 Twist the grips in any increments of power you desire to power the motor of the

bicycle and it will take off.

 This mode uses the most amount of battery power.

 This mode will give you the least miles per charge compared to the above other

modes

 This mode can be used in conjunction with any of the above modes as the motor

power is supplied while twisting the throttled grip in addition to whatever mode the

switch on the handle bar is engaged on.

About the "Green" Safety Switch on the throttle grip.

 This switch is now a standard safety feature on all our electric bikes from here on out.

It functions as a kill switch for the throttle grip. Pressing it the first time will disable the

throttle grip and pressing it a second time will enable the throttle grip once again.

 ! NOTE: This switch will NOT turn off the motor, and it will NOT disable the pedal

assist mode. It is solely to switch the throttle grip "On" or "Off".

How to read the Battery Meters and about the Li-on battery

There are 2 Battery meters on your bike. 1 is located conveniently on the handle bar showing if

the power is "On" by the light in the bottom right of the meter and the 3 bars on top of that shows

the state of the battery discharge. The other Battery meter is located on top of battery with 3

LEDs showing the current capacity of the battery in various states of discharge.

As with any Lithium-ion batteries, there are a limited number of times a battery can be charged.

While priming Lithium-ion batteries are not necessary (which means it may be charged

whenever you want without affecting its charge capacity), the number of times it is charged does

affect the overall longevity of the battery life.

To conserve battery power, switch off the power by putting the key/switch in the middle position

(a round symbol with an x over it), when the electric power is not needed.

! NOTE: In this position the key can be removed from the switch, so it can fall off the switch if

you hit a bump while riding the bicycle.