BLUEREV WARRIOR Kullanıcı Kılavuzu - Sayfa 5

Bisiklet BLUEREV WARRIOR için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. BLUEREV WARRIOR 16 sayfaları.

SAFETY CHECK BEFORE FIRST USE

Please check the following components: handlebar, stem, pedals, crank, wheels. Ensure they are properly installed and

tightened. While some of the components are pre-assembled, it is still important to make sure every component is

tightened at the indicated torque value. Failing to notice a loose component may cause it to detach during use and lead to

serious injury.

A critical part of assembling your bike is securing the front and rear wheels and checking the tightness

Wheels:

of the wheel axle nuts. Properly installed wheels are essential to the safe use of the bike.

Both tires must be inflated as specified in the manual. Failing to do so will reduce performance, increase

Tires:

tire wear, and compromise your safety.

Ensure the crank (pedal arm) is tightened at the indicated torque value.

Crank:

recommended torque 40-42 N.m)

Ensure brakes are working correctly and properly secured. When braking, apply the rear brake first,

Brakes:

then the front brake. If brakes are not correctly applied, they may lock up and you may lose control.

It is recommended to perform the above safety checks every (200-300km)/(120-180miles) or if the

bike is not used for 3 weeks.

For Your Safety

Users must become accustomed to the power controls before riding. It is highly recommended that you ride your new

bike in an open area and set the power assist level to "0". Once you feel confident operating your bike, increase the

power assist gradually.

Keeping your hands over the brake levers is good practice. The brake levers have motor inhibitors that will shut down

the motor power when applied. If for any reason you lose control, apply the brake levers immediately to shut down the

motor power. Do not try to stop your bike using your feet, as this may cause the user to lose balance.

When walking or carrying your bike, turn off the power to avoid accidentally switching on the motor. If the motor is

accidentally switched on, immediately apply the brakes to cut off the power to the motor.

(required tools: 8mm hex key,

U S E R M A N U A L