Ega Master 58869 Kullanım Talimatları Kılavuzu - Sayfa 5

Araçlar Ega Master 58869 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Ega Master 58869 12 sayfaları. Pistol type torque nutrunner

Sayfayı Yazdır

the right: increase torque. Loosen to the left: decrease torque.

6. Air motor will automatically stop when the load reaches at the pre-set torque.

7. Refer to our Air-inlet changed manual to convert into different air-inlet.

1. Air tools are adversely affected by moisture. Since air from compressor contains much

moisture and dust, it is desirable to provide a filter and lubricator in the pipeline to remove

such undesirable elements. Also take the drain out from air tank every day.

2. When using brand-new air hose or air pipe. Blow and clean the inside of air hose or pipe

before installation.

3. Keep inside of air hose or air pipe clean to prevent airdrop problem caused by the lots of

drain and dust accumulated and possibly make the inside diameter smaller in the long use.

4. When disconnect air hose from air tool while in the operation do not drop air hose end to the

floor as dust or other element may come into air hose.

5. Use air regulator to keep stable air pressure at 5.5kg/cm²-6.0kg/cm² at the toll. It is important

to get proper air pressure at the toll.

6. After lubrication, oil will discharged the exhaust upon operation. Flush motor for a few

seconds.

1. Lubrication is indispensable to air tolls. The most ideal maintenance is to install one lubricator

to a toll for automatic oil feed, but if it is not available, manual lubrication twice every day is

recommended for longer life and keeping the efficient function of mechanism.

2. For manual lubrication, disconnect air hose from bushing air inlet and full up spindle oil (#40-

#60) into the air feed in take and push the bit.

IMPORTANT!

The maker will not take responsibility for damage or malfunction as a result of the device

being incorrectly used or, applied for a purpose for whith it was not intended.

According to Waste Electrical and Electronic Equipment directive (WEEE), these ones

must be collected and arranged separately. If you have to throw them out, please, do not use

the usual rubbish. Please, contact your distributor for free recycling.

The maker guarantees to the device owner 12 months against any manufacture defect.

This guarantee do not cover the parts wich are consumables.

Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly

filled within one week after purchased the machine to the maker.

AIR SUPPLY

LUBRICATION

NOTES

GUARANTEE