d&b audiotechnik SL Z5731 Arma Kılavuzu - Sayfa 6
Hoparlör Sistemi d&b audiotechnik SL Z5731 için çevrimiçi göz atın veya pdf Arma Kılavuzu indirin. d&b audiotechnik SL Z5731 11 sayfaları. Stacking frame
Ayrıca d&b audiotechnik SL Z5731 için: Arma Kılavuzu (11 sayfalar)
Sayfayı Yazdır
6
7. At the center rear Splay link slot of the frame, release the
bottom Locking pin [2].
8. Use the upper Locking pin [1] to set the desired tilt angle
(e.g. –10°) on the upper hole grid.
9. Lower the cabinet and insert the Splay link into the slot.
10. Raise the back of the cabinet until the Splay link has engaged
and reinsert the bottom Locking pin [2] (Safety pin).
2.4 Adding further cabinets
To add further cabinets, proceed as follows:
1. Extend the Front links of the first cabinet on both sides.
↳ The Front links are spring loaded and therefore extend
automatically as soon as the Locking pins are released and
pulled out.
2. Place the next cabinet onto the first cabinet until the Front links
fit into the slots of the cabinet.
3. Insert and lock the second Locking pins of the cabinet's Front
links on both sides.
4. Slightly lift the back of the upper cabinet and release the
Locking pin [3] holding the Splay link in its park position
(Þ
).
5. Fold down the Splay link and insert Locking pin [3] to the
Tension mode hole at the bottom of the rigging strand (Þ
Assembly/Disassembly
d&b Z5731 Rigging manual 1.1 en
).