AMBIC EasiDoser Kullanım Talimatları Kılavuzu - Sayfa 7

Çiftlik Ekipmanları AMBIC EasiDoser için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. AMBIC EasiDoser 16 sayfaları.

Initial Set Up – Electrical Connections & Calibration/Programming
Functions
The EasiDoser™ control box is connected up as shown in Figure. 4 on page 5.
safety and programmable features, for which the following instructions should be read through carefully to
ensure efficient operation of the unit.
EasiDoser™ – Power Up/Down & Normal Run Displays
Action
Switch Mains Power ON
Press on/off Button
Press On/Off Button
(when switching off the unit/
leaving on standby)
Press On/Off Button
Disconnect from
Mains Power
The EasiDoser™ is supplied as either a single, twin or three pump system and can be set to run up to the
maximum number of pumps fitted. This is controlled by the user-programmable settings selected from the
menus detailed below.
Pumps are driven by low voltage DC motors and their time or speed of operation is controlled by the voltage
applied to each pump motor in order to ensure that the pumps are dispensing the correct quantity of
chemical(s).
Ambic Equipment Ltd – EasiDoser™ Operating Notes
Display
Display Number 1
Ambic Equipment
EasiDoser V1.1
Display Number 2
Waiting
for Trigger
Display Number 3
EasiDoser
Power Down
Display Number 1
Ambic Equipment
EasiDoser V1.1
Display Number 4
Powering Down
Bye
Displays for 5 seconds.
Automatically changes to NEXT display.
Pump(s) NOT running. No trigger signal
applied or start dose button pressed.
0
Displays for 2 seconds, then screen blank.
Unit in "Standby / Off" mode.
Displays for 5 seconds.
Automatically changes to display 2.
Unit completely "Off"
Warning "Bleep" before screen blank.
-7-
It includes many useful
Comment /Action
ADE7500 v1.3 (16/03/18)