Asko T780 Kullanım ve Bakım Kılavuzu - Sayfa 14

Kurutucu Asko T780 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Asko T780 16 sayfaları. User manual use & care guide t760-t780 (use & care guide - en, fr)
Ayrıca Asko T780 için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Kurulum (1 sayfalar)

Sayfayı Yazdır

REVERSING THE DOOR HINGES

The door hinges on ASKO dryers are reversible. The

dryers are shipped left-hinged. To reverse them, follow

the steps below:

WARNING!

Switch off the main power supply

before you start this procedure.

Remove the two 20 torx

screws on the bottom of

the front panel then

grasp the bottom of the

panel and pull it forward

and down.

Remove the three

screws holding the

hinge.

Supporting the door from the bottom,

pull it out and to the left as you turn

the hinge counter clockwise.

Remove the top hinge pin

then turn the hinge

upside down and put the

hinge pin into the top

hole.

Repeat steps 1–4 for the bottom hinge.

Loosen the two screws on both sides of the door

so you can remove the magnetic door latch and the

cover plate.

Remove the door

latch by pushing it up

then lifting it out from

the bottom.

Remove the cover

plate by pushing it

down then lifting it out

from the top.

Reverse steps 6 and 7 to place the door latch and

cover plate into their new positions.

10. Tighten the screws on the sides of the doors to

hold the latch and cover plate in place.

Page 14

11. Using a flathead screwdriver,

remove the plastic plugs in the

upper and lower edge of the door

and place them in the empty

holes on the opposite side.

12. Remove the screw in the top right

corner of the front panel, as

indicated in the illustration. (If you

have a condenser dryer, you will

need to open the condenser

container door.)

13. Now you are ready to mount the door on the right

side. Holding the door at an angle (as illustrated),

fit the hinge pin into the top hole.

14. Tighten the screws in the order

illustrated at right (a, b, c).

15. Replace the screw you removed

in step 12 (d).

16. Close the condenser container door and replace

the front panel.

17. Turn back on the main power.