D&R ClubMix Manuel - Sayfa 5

Müzik Mikseri D&R ClubMix için çevrimiçi göz atın veya pdf Manuel indirin. D&R ClubMix 20 sayfaları.

7.3 Insert

This is the channel insert (placed ahead of the channel fader ) . The tip is the input and the ring of the stereo

jack is the output, both at a level of 0dBu.

7.4 START CONNECTOR

On the back of the console is a stereo jack labeled START which is put there to control start function of mono

signal sources such as jingle machines. It can also be used as a red light indicator for broadcast purposes.

8.0 THE TRIPLE INPUT CHANNEL

Basically there is not much difference in use between the mono and the triple input stereo channel in

controlling the sound. The Line B input amp can be replaced by a stereo phono input with R.I.A.A. correction

amp (optional). All the other electronics in the channel are doubled to achieve a full stereo output with a

minimum of crosstalk. The panpot has been changed into a balance control to justify incorrect balanced

signals. This module is capable of mixing stereo line signals, stereo phono signals and balanced mic signals,

all in one module.

8.1 LINE A/B SWITCH

The line A/B switch selects which input jack is activated. The optional R.I.A.A. correction amp can be placed

on the pcb very easily by taking out the J2 jumpers and putting the small board up side down on the

connectors J2 and J4.

By doing this the Line B input becomes an R.I.A.A. corrected phono input. The sensitivity and frequency

response is now changed to amplify phono cartridges correctly.

In the up position of the Line A/B switch the triple input module can accept the signal from line A input. In the

down position the line B jack can now accept phono cartridges. The tip is wired to the left channel amps and

the ring to the right channel amps. The phone amp has a built in correction amplifier which follows the

standard R.I.A.A. frequency curve within

0.5 dB.

The gain control of the stereo channel adjusts the incoming level of the phono cartridge or the stereo line

input.

8.2 GAIN

The gain control of the stereo channel adjusts the incoming level of all connected sources to the line A/B and

Mic xlr connectors.

8.3 EQUALIZER

The equalizer of the stereo channel has the same characteristics as the one designed in the mono channels. It

consists of two shelving controls for high and low frequencies and a bell curve control for the mid frequencies.

(see description in mono channel)

8.4 AUX SENDS

The aux sends are factory set pre and post fader. The Aux 1 is postfader is mono and receives a summed left

right signal. Aux 2 is mono and wired pre fader and receives a summed stereo signal.

Clubmix manual page 5