Ambient LockitSlate Take 2 Manuel - Sayfa 3

Kayıt Ekipmanları Ambient LockitSlate Take 2 için çevrimiçi göz atın veya pdf Manuel indirin. Ambient LockitSlate Take 2 4 sayfaları.

Free Run Mode (C-Jam)

Press & hold power until LED lights green.

sync amongst Lockit units.

You can also use the slate as timecode source but this is not recommended as it does not reflect the

established workflow on a film set. To enable the internal generator as source, press and hold the

green button for 3 seconds until the green LED lights up twice and continues flashing green every

second.

Playback Mode (TRX)

Press & hold red, tap power.

Adaptive Display Brightness and Flip Sensor

The LockitSlate Take2 offers an all new semi-automatic brightness mode. To change the general

brightness level: hold the red button and tap the green to increase the brightness, hold green and tap

red to dim until the desired level. If the environment lightning changes the slate will automatically

adjust the brightness in several steps to match the new situation.

If you flip the slate upside down, e.g. for a tail slate, the display will automatically rotate by 180°.

Clap your Slate

On closing the slate it will display the clapped timecode, then userbits for 1 second, and finally return to

clapped time for 5 seconds.

The display will be blank and the LED flashing red, indicating the slate is

waiting to be jammed by external timecode source via either ACN, 5 pin

connector or MIDI over USB. Due to the highly accurate calibrated

reference generator a single jam suffices for day long sub-frame accurate

Similar to free run, but the system will dynamically follow the status of the

external source. For the connection via ACN the transmitting unit must

also be started in this mode.

experience quality.