Asko 12605 Kullanım Kılavuzu - Sayfa 10
Yıkayıcı Asko 12605 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Asko 12605 13 sayfaları.
Sayfayı YazdırTechnical data
Dimensions, mm
820 x 595 x 595
Weight
12605 76 kg
Washing capacity 4.5 kg of dry fabrics
Drum volume
43 litres
Spin speed
700/1500 r/min
Rated load
2060 W
Supply voltage
240 V, 50 Hz
single-phase
Heater rating
1960 W
Material of drum
Stainless steel
and barrel
Material of
Stove-enamelled
outer casing
hot-dip-galvanised
steel sheet
Mounting
Stationary: four
adjustable rubber-
covered feet
Water supply
1.5 m pex hose
hose
Supply pressure
0.1–1 MPa
(10–100 N/cm
1–10 kp/cm
15–142 PSI)
Outlet
1.7 m of poly-
propene hose,
20 mm internal
diameter
Accessories
The machine is supplied with:
• Operating instructions and
installation instructions.
• Guarantee card.
• Type-approved inlet hoses for
connection to water supply.
Optional extras::
• Decor frames
• Work top
• Plinth
• Edging frame by stacked
machines
• Frame set with pull-out shelf by
stacked machines
10
Installation
Removing the shipping brace
The shipping brace consists of two tubes
which prevent the drum from moving
around inside the machine during
transport. The tubes are secured to a
cross beam at the back of the machine.
Remove the shipping brace as follows:
1. Remove the bolts and special
washers which retain the beam,
and remove the beam.
2. Replace the washers on the
flattened part of the tubes.
Use them as tools to turn the
tubes through about 45°, as
shown in the drawing, and
pull out the tubes.
3. Turn the washers
so that they cover
the holes where
the tubes were
fitted and replace
the bolts.
2
,
Save the tubes and cross
2
,
beam, which will be needed
if the machine has to be
transported elsewhere. Fit
them in the reverse order to
that described above.
Adjusting the feet
It is important that the machine
does not move around when it is
spinning. This means that it must
be standing firmly and level on the
floor. The four feet are individually
adjustable. Set them carefully so
that the machine is standing level,
and tighten the locknuts securely.
Positioning the machine
The machine can be installed beneath a
worktop with a height of 850–900 mm.
There must be a gap of about 5 mm all
round the machine, including between
the rear edge of the machine top panel
and the wall behind.
Two tubes
inside
the machine
Cross beam
Washer
Tube
Washer
Lock nut