D'Amore Engineering SMD VM-1 Manuel - Sayfa 2

Ölçüm Cihazları D'Amore Engineering SMD VM-1 için çevrimiçi göz atın veya pdf Manuel indirin. D'Amore Engineering SMD VM-1 4 sayfaları. Voltmeter

Congratulations on your purchase of this high quality voltmeter. It is

designed to be used with automobiles, motorcycles, golf carts, ATVs,

side by sides or any place a 12V system voltmeter is needed.

The VM-1 uses analog circuitry in conjunction with a digital to analog

converter to measure the input voltage. Additionally It is internally

calibrated will not become ill calibrated by vibration.

Installation:

1. Unsnap the four tabs, one at time by pressing them toward display

while lifting the display away from the mounting plate.

2. Using the mounting plate as a template, place the flat surface of the

mounting plate against the FLAT surface that it will be mounted to and

mark the two screw holes and the rectangular slot for the wiring. Drill

the two screw holes with a 3/32" drill bit. Drill the hole for the wires with

a 3/16" drill bit.

3. Mount plate to vehicle.

distortion of plate will occur and face will not snap on properly. If no flat

surface is available it can be mounted with a high quality automotive

grade tape such as VHB tape by 3M

4. Bring the display toward the mounted plate, pass the wires through

the 3/16" hole and snap the display onto the mounting plate.

5. Make the following electrical connections:

Voltage Sense Wire =

Turn On Trigger = White

Ground = BLACK

Specifications:

Display Range = 10.1 - 15.8 Volts DC

Accuracy = +/- 0.15 Volts

Response Time from 10.1 - 15.8 Volts = 130milliseconds

MUST be mounted on a flat surface or

RED