Ambient Technologies TOUCH LIGHT TLM Kurulum ve Kullanım Talimatları - Sayfa 2

Uzaktan Kumanda Ambient Technologies TOUCH LIGHT TLM için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları indirin. Ambient Technologies TOUCH LIGHT TLM 3 sayfaları. On/off remote control

Sayfayı Yazdır
Remote Receiver:
The remote receiver may be wall mounted or installed in the appliance per the
appliance homeowner's manual. Refer to the Homeowner's Manual for special
installation instructions. If wall mounted, the remote receiver must be installed
in a junction box with cover plate provided. Failure to follow the installation
instructions found in the appropriate Homeowner's Manual will void the warranty
and may cause a fire hazard.
Installing Batteries:
The remote receiver uses four (4) "AA"- size batteries. To install batteries,
1.
Remove the slide switch by gently pulling straight out.
2.
Use your thumb and index finger to gently pull down the L-bracket.
3.
Open the battery door by pressing the two tabs located on the door.
4.
Install the batteries as indicated in the receiver cover.
5.
Close the battery door until the door tab snaps in place.
6.
To install the receiver into a wall junction box, install the receiver with
the screws provided .
7.
If you decided to install the receiver into the appliance, reinstall the L-
bracket.
8.
Gently, install the slide switch back to the receiver stem.
9.
The batteries should be replaced at least once every 6 months or when the battery indicator flashes.
Connecting the Receiver to your appliance:
This system comes with an 18 inch wire assembly. Insert the white terminal to the back of the receiver. The
terminal wire block can only be installed one way. Do not force the terminal plug onto the receiver.
Connect the wiring terminal two (2) _" female spade terminals to the appliance. Refer to the appropriate
Homeowner's Manual for proper wiring connections to the appliance. Your appliance may have other options to
connect wiring from receiver. For applications longer than 18 inches, use 18 gauge wire, 105ºC rated, with no
splices. Connect to the two (2) 1/4" female spade wiring terminals. Wire can be no longer than 20 feet.
Make sure that the wires do not contact the appliances any place other than at the terminals.
Exposure to temperatures higher than 105C (250ºF) may cause the receiver to malfunction or
fire hazard.
Touch Light Transmitter:
50D0092 Rev 4 Feb 2005
Page 3 of 9
Slide Switch
L-Bracket
Battery Door
Ambient Technologies
A Division Of