Ambient Technologies WWTD Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 5

Uzaktan Kumanda Ambient Technologies WWTD için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Ambient Technologies WWTD 10 sayfaları. Wireless wall thermostatic on/off remote control

Sayfayı Yazdır

Do not use two (2) or more remote control systems in the same area with the same dip switch

settings, as they will communicate with each other. This may cause the appliances to

malfunction.

Wireless Wall Transmitter:

The transmitter will operate the remote receiver from 1foot to a maximum of 30 feet. The distance is reduced when

batteries are low or when the receiver is inside a metal enclosure.

Initial start up:

1. After initial power up or when RESET button is pressed, the

transmitter is reset. The reset button is located behind the flip door.

2. During system reset, all features of the LCD will be visible. After one

second, the LCD will be initialized. A typical reset display is shown

above. Note that the temperature scale is degree F.

3. While °F is flashing, press SET and TIME/CANCEL more than 3

seconds to select between °C and °F display. It will exit setting mode

automatically after 10 seconds if no key is pressed.

4. After reset the transmitter is operating in manual mode. The time and

room temperature are shown as above.

50D0077 Rev 1

OPERATIONS:

Page 5 of 10

General:

The

RCT

Remote

Control

has four

(4 )

operatin

modes:

Manual,

Timer,

Auto,

and

Auto-P.

The

control

system

can be

set to

tempera

ture

ranges

between

45°F

and

90°F.

Ambient Technologies

A Division Of MHS