Ambirad TORNADO Посібник з монтажу та експлуатації - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Газовий обігрівач Ambirad TORNADO. Ambirad TORNADO 16 сторінок. Gas fired mobile heater
Також для Ambirad TORNADO: Інструкція з експлуатації (8 сторінок)

Друкувати сторінку

User & Operating Instructions.

Ensure that you have read all other detail

included in these instructions prior to following

the operating instructions detailed below.

The heater can be operated on either a 110 or

230 volt electrical supply by inserting a suitable

connector/lead into either the 110 or 230 volt

appliance connectors.

Plug the supply lead into the connector on the

rear of the product.

Select the appropriate voltage.

Uncoil the hose from around the rear ring.

Attach the regulator to the gas bottle using the

spanner provided. Note Left hand thread.

Check for any gas leaks with soapy liquid

solution .

Ensure the hose is not twisted or damaged and

that the gas bottle is positioned at the side of the

unit to avoid heating at the outlet.

Note When positioning the heater please ensure

that all inlets and outlets are unrestricted there

are no combustible materials in the vicinity.

Please ensure the heated air is not directed

towards the gas bottle.

The temperature of the building can be

controlled using an optional remote thermostat.

Select remote thermostat. Plug the remote stat

lead into the remote stat socket.

After switching on the mains supply, ignition is

controlled

the

incorporated on the burner assembly.

Firstly you will hear the combustion and

convection fans running. ( Note - If the

combustion fan does not operate, then check to

Patented under European patent number 1561074

AmbiRad Limited Fens Pool Avenue

Brierley Hill West Midlands DY5 1QA

United Kingdom.

Telephone 01384 489700

Facsimile 01384 489707

[email protected]

Website

Technical Suport

automatic

ignition

www.ambirad.co.uk

www.s-i-d.co.uk

see if the overheat stat reset has tripped. This is

located behind the combustion fan access

door - see 7.3)

After a delay of 15-20 seconds, you will hear a

'Clicking' noise, as the igniter assembly attempts

to light the gas. On ignition the amber light will

illuminate. If ignition does not occur then the light

turns off indicating there is potentially air in the

gas line.

Re-ignition can be attempted by restarting the

appliance. If ignition still does not occur and the

lockout lamp illuminates, it is likely that the low

gas pressure switch is activated indicating that

the LPG bottles are exhausted of gas and

require changing. If after changing the gas

bottles and ignition still cannot be achieved,

please refer to section 8.1 Fault Finding.

Note Connecting and disconnecting cylinders

MUST take place in a flame free atmosphere.

When the appliance is not going to be used for a

period of time the unit MUST be disconnected

from the electrical mains and gas cylinder.

When heating is complete, turn OFF the gas

supply. Leave the electric supply turned ON to

enable the combustion fan to operate for 10

minutes to cool the product prior to moving.

After cooling is complete, switch the 3 position

rocker switch on the rear of the product to the

OFF position and disconnect from the electric

supply and remove the electrical connector.

Disconnect the gas supply and recoil the hose

around the rear ring assembly.

unit

Note If the appliance is not to be used for a

period of time, ensure that the appliance is

stored in a dry environment.

AmbiRad is a registered trademark of AmbiRad Limited. Because of continuous product

innovation, AmbiRad reserve the right to change product specification without due notice