ACR Electronics PathFinder3 SART-3 Посібник з підтримки продукту - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з підтримки продукту для Морське радіо ACR Electronics PathFinder3 SART-3. ACR Electronics PathFinder3 SART-3 20 сторінок. Search and rescue transponder

Друкувати сторінку

1. Section 5 - Maintenance

SECTION 5 - MAINTENANCE

This chart is a summary of the procedures described below.

Time interval

Every two months

Every year

Every-two-months inspection

The SART is a safety device; it must be regularly checked at least every

two months as follows.

1.) Visually inspect the casing for cracks & punctures.

2.) Extend the pole and check that it operates correctly, and then return the

pole to its housing.

3.) Check to ensure the tether lanyard is neatly bundled and firmly secured

to the SART. Ensure the lanyard is NOT tied to any part of the vessel.

4.) Check that the battery expiry label shows sufficient battery life to cover

the next routine voyage.

5.) Ensure the safety lock is in place and the integrity seal is not broken.

Confidence check

Push the switch ring to the left and into the test position and hold it there for

10 seconds. Confirm the SART does either (a) or (b) below, then release

the switch.

a) Beeps once and the red light flashes continuously every 4 seconds (no

Radar within range).

b) Beeps and the red light flashes every 1 second (answering radar).

Multiple SART Interrogation Test

If your vessel has two PathFinder™

test each other. This test requires that each SART is held independently, 5

meters away from one another. Turn and hold one SART into the TEST

position. It will beep once and the red light flashes continuously every 4

seconds. Next place the 2

SART beeps once every time the 2

Repeat this sequence to test the 2

Y1-03-0170H

Maintenance to do

Visual inspection

Battery expiry date check

Pole operation check

Lanyard check

Safety lock check

Confidence check

Functional test

SARTs on board they may be used to

SART into the test mode. Confirm that the 1

SART is turned into the test mode.

SART.