AmbuTrak 1001 Інструкція - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція для GPS AmbuTrak 1001. AmbuTrak 1001 4 сторінки.

1. Attach computer to crossbar of walker using 2 zip ties. Tie securely. Cut excess zip tie.

(Standard 2-wheel walker on left, rollator setup on right)

2. Next, use two zip ties to secure sensor close to wheel spokes. Position sensor very close to

wheel spokes, without causing sensor to rub. Tie very securely. Trim excess zip tie.

(Standard 2-wheeled walker on left, rollator setup on right.)

3. Use final zip tie to remove slack from sensor line and tie to walker. Leave somewhat loose,

enough to allow line to be adjusted based on future height changes of walker.

4. Attach gray colored clip (with magnet) to wheel spoke. The flat surface of clip must face towards

sensor on inside of walker. (Lay walker on its side and use two hands to make this step easier.).

(See next page for steps 4 and 5)