AMC HEADPHONES AMP Series Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Підсилювач AMC HEADPHONES AMP Series. AMC HEADPHONES AMP Series 16 сторінок. Stereo preamplifier
Друкувати сторінкуINPUTS
All audio Inputs are via RCA type RCA
connectors. All the RCA sockets on
your AMC amplifier are marked "L" for
left and "R" for right channels, with the
left channels nearer the top of the
cabinet.
Your connection leads will
have a white or black plug for left, and a
red plug for right.
1.
PHONO GROUND TERMINAL
The Ground Terminal is for you to
connect ground wire of your turntable in
order to eliminate possible interference
and hum loop for best possible sound
quality.
2.
PHONO MM/MC INPUT SELECTION
SWITCH
3. PHONO INPUT (OPTION COAXIAL
IN)
This input is suitable for both moving
magnet and moving coil cartridges. For
either type of cartridge the plugs on your
turntable lead should be connected to the
phono input sockets on the rear panel of
your amplifier.
A
switch
adjacent
input sockets allows the selection of
either MM or MC input. Facing the
back of the amplifier, move the switch
to the right for use with MM or high output
MC cartridges and to the left for use
with MC cartridges.
Note: Never operate the MM/MC selector
switch with the volume control turned up
as the resultant electrical surge may
damage your loudspeakers.
To minimize hum the turntable lead
should be kept away from the mains
wiring, and any separate turntable ground
lead should be attached firmly to the
earth terminal on the rear of the amplifier.
4. OPT/ USB / AUXILIARY INPUT
The OPT /USB /Auxiliary input is designed for using
with Optical (OPT) or USB input located at Top Left
corner of rear panel for Hi-Res Streamers like D-
STREAM PRIMO-HD etc or and other optical
sources or for any extra source processing a line
level output, perhaps a second tuner or CD
player, or an additional tape or video recorder
wired for replay only.
Use OPT input only. for using AUX inputs, please
take OPT or USB output connector out from
CN201
5. TUNER INPUT
The Tuner input is suitable for use with most AM/
FM tuners. Connect your tuner to the amplifier
using the RCA sockets marked
"Tuner".
6. CD INPUT
The CD input is suitable for use with any CD
player. Connect your CD player to the amplifier
using the RCA sockets marked "CD".
7. PRE OUT 1
There are two pre-outs, PRE-OUT 1
& PRE-OUT 2 for the convenience
to have the pre-amp outputs to be
connected to more others equipments.
to
the
RCA
The two pre-outs are connected in
parallel together.
5