AMC IF 400T Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Датчики безпеки AMC IF 400T. AMC IF 400T 4 сторінки. Multiband wireless curtain shape infrared detector
Друкувати сторінку
the detector active avoiding the return in the rest state. If, on the contrary, during this period it doesn't
detect any movement it will return to the rest state ready to send another signal. The return to the rest
state is notified by a LED's very fast blink, almost imperceptible to optimize the batterie's consumption.
The test mode is automatically activated during the first ignition, the duration is 20 cycles (the detector
will not rest but it will restore 10/20 seconds after each violation for a total of 20 times. After the counting,
if it is violated during the restoration, the detector will stand-by for about 2min30sec. To return the sensor
in test mode simply open and then reseal the anti-opening tamper switch.
NORMAL MODE Working:
Finished the test phase (50 cycles of transmission without going in stand-by), after the first detection
with radio signal transmission, begins the counting time of 20 seconds during which the detector will try
to return in the rest state. If, at the end of counting, the detector will not be returned in the rest state, due
to continuous detections, will start a 2.5 minutes period of inhibition in POWER SAFE mode, during
which the detector can no longer send alarm detection radio signals (anyway it remains active for all
other alerts). Each movement detected during the period of inhibition will prolong the same other 2.5
minutes. The end of the period of inhibition is indicated by a LED's fast blink.
INSTALLATION
- Unscrew the closing screws and fix the housing in the desired mounting place.
To program the device into the receiver,
insert the battery in the proper space,
following the right polarity, and then use
the LEARN Button to send the Learning
Signal to the receiver.
Note: For the complete procedure
please refer to the Receiver's Manual.
To let become active the DIP-SWITCH
configuration press the LEARN Button
and check if the LED blinks fast.
Once placed the device in the desired
position please use the Receiver's Test
Tools to check the radio range, the perfect
box closure, the battery level etc.
Please refer to the Receiver's Manual.
ADJUSTMENTS AND FUNCTIONAL NOTES
This detector is been designed to be installed as passages protection, for example between window and
shutter and/or rolling shutter, otherwise to protect doors and main doors. So for the correct installation
needs to be considered the lens position that must always be oriented downward (Fig.3). Is also
important the range adjustment that must be the most similar to the desired real coverage. Acting to the
RANGE Trimmer in Clockwise direction the range will be increased (Fig.1). Please keep in mind that
during the installation is possible that the detector needs to be oriented and/or tilted a little to satisfy the
coverage requirements (Fig.3).
www.amcelettronica.com
Unscrew Here to Open
Fig. 2
IF400T - v 1.0