AMCI SD17060B Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Сервоприводи AMCI SD17060B. AMCI SD17060B 20 сторінок. Stepper drives

Друкувати сторінку

Outline Drawing

There are two ways to mount the SD17060B.



The first method is with four #10-32 screws into its side panel.



The second method is by the mounting tabs. Mounting tabs are for #6 screws.

There are airflow holes in the top and bottom of the enclosure. To ensure adequate convec-

tional airflow, the driver must be mounted in the orientation shown in the drawing.

0.152"

0.312"

0.152"

(3.86)

Grounding

The SD17060B must be grounded for proper operation. The

nected to the SD17060B enclosure and is a sufficient grounding point for most applications. When mounted

the SD17060B on a surface that is electrically conductive and grounded, you should also take steps to ensure

that the two are electrically bonded together. If necessary, remove paint for the bolt mounting surfaces of the

panel to ensure adequate electrical bonding.

Airflow and Wiring Space

To ensure adequate airflow and wiring space, you need two inches (50 mm) of space above and below the

driver, one and one-half inches (37 mm) of space to the left and right of the driver, and one inch (25 mm) of

space in front of the driver. These dimensions are typical for convectional cooling. If you have an active

cooling system such as enclosure fans, you will be able to mount the drivers closer together.

MOUNTING THE SD17060B

Minimum and maximum screw lengths should be observed to prevent a screw from

shorting to the PC Board.

2.05"

(52.1)

(3.86)

dia.

1.10"

dia.

(7.92)

(27.9)

0.118"

DIR/CCW

(4.78)

DIR/CCW

STEP/CW

DISABLE

FAULT

STEP/FAULT

INTERLOCK

B CTAP

6.71"

(170.4)

EARTH GND

A CTAP

INTERLOCK

POWER

GND

AC POWER

95 – 132 V

50/60 Hz

0.60"

(15.2)

1.000"

typ.

(25.40)

Min. screw length = 0.31"

(7.9)

Max. screw length = 0.62"

(15.8)

7.00"

(177.8)

2.750" (69.85)

0.875"

(22.23)

4.00" (101.6)

connection on the power connector is con-

GND

ADVANCED MICRO CONTROLS INC.

#10-32 UNF-2B.

Four places.

+ thickness of mounting panel.

6.15"

(156.2)

4.000"

(101.60)

1.073"

(27.25)