Amcor 12000E Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Кондиціонер Amcor 12000E. Amcor 12000E 14 сторінок. Plm mono blocs
Також для Amcor 12000E: Посібник користувача (8 сторінок), Інструкція з експлуатації (13 сторінок)
Друкувати сторінку
STORAGE
See the instructions "Emptying the water container".
Drain the condensed water completely.
Clean or change the filter.
Put the unit on a warm day in fan mode for a couple of hours to ensure that the
inside can dry out completely.
Store the power cable as shown, protect the unit against dust (put back into its
original carton) and store in a dry place not accessible for children.
Do not stock heavy objects on top of the unit.
TROUBLE SHOOTING
Never try to repair or dismantle the air condition yourself. Incompetent repairs result in loss of warranty
and can endanger the user and the property.
r P
b o
e l
m
The air
No power supply.
conditioner does
Is the power light fl ashing?
not function.
Timer function is active.
The air
The unit is in direct sunlight.
conditioner does
Windows or doors open, many
not seem to
people or a heat source in the room.
perform.
The filter is dirty.
Air inlet or air outlet blocked.
Room temperature lower than the
selected value.
The unit is noisy. Unit stands uneven.
The compressor
The overheat protection is probably
does not work.
activated.
The remote
Distance too great.
control does not
Remote control signal not detected
function.
by the control panel.
The batteries are drained.
To correct problems that have not been described in the table and/or if the recommended solutions fail
to solve the problem, contact an authorized service centre.
C
u a
e s
Connect to a functioning outlet and switch on.
Empty the drain pan.
Deactivate the TIMER function.
Close curtains.
Close doors and windows, place an extra air
conditioner.
Clean or replace the fi lter.
Remove the blockage.
Change temperature selection. Set at the
lowest possible setting: 16 °C.
Place on an even, solid surface (less
vibrations).
Wait 3 minutes until the temperature has
decreased, then turn on the unit again.
Make sure the remote control is correctly
aimed at the control panel.
Replace the batteries.
S
l o
t u
o i
n