Amcor ALTL12000EH Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Кондиціонер Amcor ALTL12000EH. Amcor ALTL12000EH 8 сторінок. Amcor portable air conditioner owner's manual altl -12,000e, altl -12,000eh
Друкувати сторінку
Installation
Window Kit Installation
In order for this unit to function
2. Attach Slide Bar Connector,
properly, it must be vented to the
(Round Connector) to the
outside.
other end of the Hose by
extending hose at least 6".
Fitting the Exhaust Hose through
Then tighten Hose by turning
the window is easy. Please see
the (Round Connector)
below.
clockwise.
1. Extend Hose at least 6" and
insert it into back of the unit,
tightening into place by turning
it clockwise.
Wall Connection
1. Make a hole (5.1" in diameter)
3. Extend one end of the Exhaust
in the wall.
Pipe (part #11) and screw into
the Round Connector by
2. Insert the Round Connector
turning clockwise.
(part #13) into the hole and
hold in place by using 4 small
4. Extend other end of exhaust
screws (not supplied).
pipe and screw in Adaptor (part
#10) by turning clockwise.
Slide Bar
Connector
3. Place Adjustable Slide Bar in
the window and expand so it
fits tightly.
4. Lower the window.
5. Make sure the Hose has
no kinks.
Slide Bar has 3 sections which
allows installation in windows up
to 48" in width.
Round
Connector
5. Push Adaptor to fit firmly
over the opening on the back
of the unit.
** When not in use, cover the
Round Connector and hole
with Cap (part #14).
6
Installation
Mounting the Exhaust Pipe
• The supplied Exhaust Hose can be
extended from 1 foot to 5 feet
for mounting. It is recommended that
you use the shortest possible length of Hose.
• Take care to prevent any kink or
bend in the middle of the Exhaust
Hose, as this will trap hot exhaust air,
which will radiate back into the room.
WARNING!
The length of the Exhaust Pipe is specially
designed according to the specification of
this product.
Do not replace or extend it with your own hose
as this could cause the unit to malfunction.
Cleaning the Filter
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters
and then rinse them thoroughly under running water (no hotter than 104ºF)
Dry thoroughly before replacing.
Notice! Never operate the unit without the filters.
7