Amcor AHD-65E Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Осушувач повітря Amcor AHD-65E. Amcor AHD-65E 6 сторінок. 65 pint dehumidifier

Друкувати сторінку

Before Use

Read this manual carefully. It contains instructions to help you use,

maintain and enjoy your dehumidifier.

ELECTRICAL SAFETY

Grounding

This dehumidifier must be grounded. Grounding reduces the risk of electric shock by

providing an escape wire for the electric current. The power cord has a grounding wire

with a grounding plug. Plug it into an outlet that is properly installed and grounded.

WARNING: Improper use of the grounding plug can result in a risk of electric shock. Call

a qualified electrician if you don't understand the grounding instructions or if you are not

sure if the dehumidifier is properly grounded. If the wall outlet is not grounded, please

contact an electrician to have it replaced with a properly grounded outlet.

Do not, under any circumstances, cut or remove the third (ground) prong from the

power cord.

Adapter Plug

Because most 2-prong outlets are not grounded, we strongly advise against using an adapter

plug. However, a temporary connection may be made where local codes permit and if the

2-prong wall outlet is properly grounded. Make sure the larger prong of the adapter goes

into the large slot to provide proper polarity.

For Proper Grounding

1. Ground the adapter to the outlet by using the outlet cover screw to secure the ground

terminal to the outlet box.

2. Please confirm the outlet is grounded through the house wiring. If the grounding

connector breaks. DO NOT USE the dehumidifier until a proper ground has again

been made.

Extension Cord

If an extension cord is required to reach the nearest wall receptacle, use only a UL-listed,

3-wire, grounding type, 16 AWG, 15A, 125V appliance extension cord.

Operation

Button

Control Panel

HUMISIDTAT

1. POWER

2. HUMIDISTAT: This allows you to adjust the humidity of the air.

You may set the humidity by pressing the UP and DOWN buttons.

3. TIMER: Your dehumidifier can be set to go on or off at your desire.

This can be done up to 24 hours in advance.

4. TWO-SPEED FAN: When this you can control the fan speed.

You have 2 levels of Fan Speed for you to set at you desired level.

LOW will circulate air at the lower velocity and HIGH will circulate at the higher velocity.

5. CURRENT TEMP/TIMER SET DISPLAY: When machine is running, it displays the

current temperature. Press the "TIMER" button to set the machine to shut off or

turn on automatically after a specified amount of time.

6. BUCKET FULL INDICATOR: When light comes on, automatic flow control stops the

unit. Turn the unit off by pressing "POWER" key before emptying the bucket.

7. AUTO RESTART: Turns the unit on automatically when the power returns

8. AUTO-DEFROST SENSOR (BUILT-IN): When temperature gets down to 60° F or

lower, ice may form on the evaporator coils preventing removal of moisture.

The IC stops the compressor when this happens but allows the fan to continue running.

When the ice is no longer present it starts the compressor.

9. CURRENT TEMP/TIMER SET DISPLAY: When machine is running, it displays the

current temperature. Press the "TIMER" button to set the machine to shut off or

turn on automatically after a specified amount of time.

10. CURRENT HUMIDITY/SETTING HUMIDITY DISPLAY: Displays the current humidity.

If you press the "ADJUST HUMIDITY" button, the screen will show the humidity you set

and be back to show the ambient humidity 5 seconds later.

Setting Humidity Range: 40%RH ~ 70%RH

Display Humidity Range: (LO)30%RH ~ (HI)90%RH