Floe PWC1300 Швидкий старт Quide - Сторінка 8
Переглянути онлайн або завантажити pdf Швидкий старт Quide для Підйомні системи Floe PWC1300. Floe PWC1300 8 сторінок. Anchoring system
Також для Floe PWC1300: Інструкція з монтажу Посібник з монтажу (12 сторінок)
Друкувати сторінкуFig. 5A
IMPORTANT NOTE:
The lift should be installed with 6" of water above the
top of the bunks while the lift is in the lowered position.
This will provide adaquete clearence for launching
and docking of your watercraft and also help prevent
float off in the raised position during high wave conditions.
Lifting Winch and Cable Installation Instructions:
Fig. 5A Location
Insert winch post (item #11) into front leg of right
side frame weldment (item #1). Leave 5" of winch
post exposed. Fasten with (1) HHCS 3/8-16 x 3/4",
(1) 3/8-16 nut, & (1) 3/8" flat washer (items #14,
21, & 23). Torque to 35 ft. lbs.
Install manual winch (item #26) with the crank
spindle on the bottom and the cable (item 28) has
to be rerouted behind the crank spindle and out the
bottom.
Loosen and remove the nut, bolt, and washers (end
without chain attached) on the 2" pulley assembly
(item #13). Insert the cable (item #28) and replace
hardware. Tighten to remove excess play in pulley.
Attach 2" pulley assembly to right side frame
weldment with (1) HHCS 3/8-16 x 3", (1) 3/8-16
nut, & (1) 3/8" flatwasher (items #17,19, & 21).
Torque to 10 ft. lbs.
Thread the other end of the cable through the (2) 3"
cradle pulley assemblies (item #8) & attach the
swedged end of the cable to the left side weldment
(item #2) with (1) HHCS 3/8-16 x 3", (1) 3/8-16
nut, & (1) 3/8" flat washer (items # 17,19, & 21).
Torque to 10 ft. lbs.
Install (2) HHCS 1/4-20 x 1 3/4", & (2) 1/4-20
nylock nuts (items #31,& 32) through 3" pulley
assemblies (items #8). Torque to 10 ft. lbs.
WARNING:
Watercraft must float freely over bunks before lifting. The weight of
the watercraft must never be on the lift when it is in it's lowest
position. Failure to follow this procedure may result in severe
damage to your lift and/or watercraft and will void your warranty.
Sheet 8 of 8
Step 5