Amcrest A5TN28-W Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Камера спостереження Amcrest A5TN28-W. Amcrest A5TN28-W 8 сторінок. Ultrahd 5mp full color analog camera
Друкувати сторінку
Product Introduction
This series of camera is adopted with CMOS image sensors that provide high performance, high megapixel resolution
that supports 5MP video. It supports monitoring signals and audio via a coaxial transmission and standard BNC
connection and built in microphone. Transmission distances can range more than 700m (2296ft) @ 5MP. This series
can also support CVI/TVI/AHD/Analog output as well as recognize high speed, long distance, and real time video
transmissions.
Features
1/2.7" CMOS
5MP (2592x1944)@20fps
2D NR, Full-Color
DC12V, 2.0A
Installation
Before physically installing your camera, make sure the mounting surface can support up to 3x the weight of the
camera.
1)
Remove the base portion of the camera using the included star tool.
2)
Locate the position in which you would like to place your camera and using the base of the camera, mark
the installation holes with a marker on the mounting surface. These holes will be used to drill the holes needed to
mount your camera.
3)
Using a drill bit that is the same diameter or slightly smaller diameter than the included drywall wall
anchors, drill the 4 holes and insert the wall anchors into the holes.
Note: The wall anchors should be in the same bag as the screws and are designed to secure the screws onto the
mounting surface.
4)
Attach the power cable and BNC cabling to the camera. (If you are running the cables through a mounting
surface, use a 1" paddle bit to bore a hole for the cables.)
5)
Attach the cables to the BNC connection and power supply and place the base of the camera on the wall
anchors lining the holes to the mounting surface. Please note, if you are running the cables through the mounting
surface, run the cables into the hole, if you are running the cables on the side of the camera, ensure the cables are
ran the groove found on the side of the mounting plate.
4