Amcrest AMC4KBC6-W Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Камера спостереження Amcrest AMC4KBC6-W. Amcrest AMC4KBC6-W 9 сторінок. 4k analog hdcvi bullet camera
Друкувати сторінку
3)
Attach the power cable and BNC cabling to the camera. (If you are running the cables through a mounting
surface, use a 1" paddle bit to bore a hole for the cables.)
4)
Place the base of the camera on the wall anchors lining the holes to the mounting surface. Then, using a
Phillips head screwdriver, secure the screws and base of the camera to the mounting surface.
Note: To adjust the camera, you can loosen the adjustment screws near the base of the camera. Adjust the
position as desired and tighten when complete.
Connection
To connect your camera to your DVR, please follow the steps provided below:
Step 1: Connect a BNC (coaxial) cable to the video out connection of your camera.
Step 2: Connect the male end of the DC power connector of the BNC (coaxial) cable to the female end of the power
connector of the camera.
Step 3: Connect the BNC (coaxial) cable to a video out channel on the back of your DVR.
Step 4: Connect the male end of the DC power connector of the power adapter to the female end of the power
connector of the BNC (coaxial) cable. Plug in the power adapter to apply power to the camera.
For more information on the installation process described, refer to the image below for more details.
Audio
The camera has a built-in microphone which allows the camera to transmit one-way audio through a coaxial
connection. To enable the microphone on your camera, please make sure the following settings on your DVR are
enabled.
-
In the Management menu, click on Encode to enter the encode settings menu for your DVR.
-
Click on "More Settings" and make sure that the Audio Encode checkbox is enabled.
-
Set the encode settings to AAC and then change the input from "Local" to "HDCVI".
-
Click Save to save the encode settings to your device.
Note: If you are using the system on your mobile device, ensure that the Video Steam checkbox is enabled in the
Sub stream menu of your DVR.
Using an Amcrest 4-in-1 Camera
Quadbrid or 4-in-1 technology, allows for a flexible means of providing HD-CVI, HD-TVI, AHD, and Analog
formatted video to your DVR. The signal is transmitted uncompressed, which eliminates latency and allows for
real-time, highly reliable video security without loss or delay. The cameras connect point-to-point directly to the
DVR (BNC) which provides a highly secure, closed network, as well as a painless and non-complex plug-and-play
setup process. The toggle switch for your 4-in-1 camera is represented in the image below:
5