Flofab RWU series Посібник з експлуатації, технічного обслуговування та монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з експлуатації, технічного обслуговування та монтажу для Водонагрівач Flofab RWU series. Flofab RWU series 11 сторінок. Hot water storage tanks

Друкувати сторінку

Connecting a Pressure Relief Valve

Each FLOFAB® Tank has been built to exact customer specifications. An A.S.M.E. approved pressure

or pressure / temperature relief valve must be installed in the tank. While the pressure rating of the

valve can be lower, it must not exceed the working pressure of the tank.

Note: The working pressure of each tank is listed on the Submittal Sheet and stamped on

the data

plate attached to the tank for reference.

▼ Installing a pressure relief valve that is rated for a higher pressure then the working pressure of

the tank will create a potentially dangerous situation. The pressure relief valve must not exceed the

working pressure of the tank and should be installed following all accepted / recommended proce-

dures to avoid possible injury or death.

Note: For all piping connections, the use and / or type of joint compound or sealer on the

joint should be determined by referring to local codes, accepted practices, or the require-

ments of the installing contractor.

Connecting Components to the Tank

Care should be taken when connecting any component(s) to the tank. Each component should be

carefully mounted to the appropriate fitting and properly aligned before tightening.

Note: For all piping connections, the use and / or type of joint compound or sealer on the

joint should be determined by referring to local codes, accepted practices, or the require-

ments of the installing contractor.

After the tank is filled, each fitting should be examined to assure that no leaks are present. Leakage

at fittings can cause the outside of tank to rust, effectively shortening the life of the tank.

I.O.M - HOT WATER STORAGE TANKS - RLU/RWU/RSE

INSTALLATION

SINCE 1981