ACR STOVES Langdale Технічний посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Технічний посібник для Піч ACR STOVES Langdale. ACR STOVES Langdale 9 сторінок. Woodburning cast iron stove
Друкувати сторінкуIMPORTANT INFORMATION
To ensure that you gain the most from your purchase, please take a few minutes
to read through this manual before lighting the appliance for the first time.
Since April 2002 only registered competent installers can install solid fuel appliances. Installations
carried out by non-registered installers must be inspected by local authority building control.
For more information please contact hetas at: www.hetas.co.uk or telephone: 0845 6345626
• Before installation and/or use of this
appliance please read these instructions
carefully to ensure that all requirements are
fully understood.
• This appliance must be installed by a
registered engineer, or approved by building
control, failure to do so may endanger life and
property.
• All the instructions in this manual should work
in conjuction with building regulations
document J, if there is a variation the most
stringent requirement should be adhered to.
• The installation of this appliance must comply
with current Building Regulations and local
regulations, including those referring to
national and European standards need to be
complied with when installing the appliance.
• Do not operate this appliance if it becomes
damaged.
• Improper use, maintenance or fitting parts
other than those approved by the
manufacturer could lead to the appliance
becoming damaged or unsafe which in turn
could lead to personal injury or damage to
the property and will void the warranty.
• The appliance must not be modified in
anyway unless authorised by ACR Heat
Products Ltd.
• The appliance should be inspected regularly
to ensure the airways are clean and free from
obstruction and the chimney swept at least
once a year.
Before installation, please ensure that the correct model has been supplied.
Please make a note of the serial number of your appliance in the space provided on the front cover
of this manual as this will be requested if you require technical assistance in the future.
Please also ensure that the commissioning checklist at the rear of the manual is completed in full.
• The external surfaces of this appliance will be
very hot to the touch when in operation and
due care will need to be taken when
operating the appliance to ensure safety. A
fire guard should be fitted if it is likely that the
elderly, infirm or children may come into
contact with the appliance.
• This appliance has been designed for
intermittent operation.
• This appliance must not be used as an
incinerator.
• Each installation is unique to the property, the
information contained in this manual may not
give exact installation requirements for your
installation.
• The installation must comply with Building
Regulations, European Standards and Local
authority bylaws.
Asbestos
This appliance contains no asbestos, if there is
the possibility of disturbing any asbestos in the
installation of this appliance then specialist
advise must be sought and appropriate
precautions taken.
Metal Parts
This appliance may contain sharp metal edges,
take care when installing or servicing this
appliance to avoid personal injury. Please use
appropriate personal protective equipment at
all times.
Langdale Specifications
Nominal heat output
Chimney draft required
Height
Width
Depth
Weight
Air Requirement
Flue Mass Gas Flow
2
CO @ 13% O
Mean Flue Gas Temperature
Efficiency
Log Length
*** Please note that Building Regulations Document J advises that additional permanent air supply is
required for appliances with an output of above 5Kw.
With modern properties additional air may be required as Document J suggests that adequate air
would be a benefit.
• If design air permeability ≥5.0m³/ (h.m²) then 550mm²/kW of appliance rated output above 5kW
Or
• If design air permeability ≤5.0m³/ (h.m²) then 550mm²/kW of appliance rated output
• If in doubt, please consult your registered installer for advice.
NOTE: DO NOT INSTALL IN A ROOM CONTAINING AN EXTRACTOR FAN
665
9 kW - Wood
12Pa
740 mm
665 mm
370 mm
136 kg
2200 sq mm ***
??g/s - Wood
?? Wood vol %
??°C - Wood
??% - Wood
Up To 500 mm
370