Aero Hawk Field Hawk Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дрони Aero Hawk Field Hawk. Aero Hawk Field Hawk 14 сторінок.

1. Once you have created your

mission & Uploaded it to your

Field Hawk. Take your Field

Hawk to the location you with

to fly.

4. Arm the drone by pressing

and holding the safety button

on top of the drone until it is

solid red. Then back away a

couple meters from the drone

2. Plug the Battery back into the Field

Hawk and place the Field Hawk on the

Ground as shown below.

5. Start the motors by holding the

throttle down and right until you

see them start up. If you need to

stop the motors turn the throttle

down and left.

Start motors

Stop motors

Flight Mode Switch

Auto: Initiates Mission

RTL: Returns Drone to Arming Location

Loiter: Precision Maneuvering

Refer Questions to [email protected]

Flying

3. Turn on the Remote Control. The LED indicators on the

camera and drone will turn GREEN when ready.

6. Flip the flight mode switch to

auto, raise the throttle a little bit

and the drone will take off on its

mission. Keep an eye on it.

7. Once it lands, the motors will stop

by themselves.Push the flight mode

switch down to loiter. Disarm the

drone and unplug the battery. You are

now ready to upload your pictures to

your AeroHawk Maps software.

Motor emergency stop :