AME MM-2 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автосигналізація AME MM-2. AME MM-2 18 сторінок.
Також для AME MM-2: Посібник користувача (20 сторінок)

Друкувати сторінку

Installation Manual

General recommendations

Before you begin the installation, disconnect the " " terminal of the car battery.

1. The main unit is to be installed inside the passenger compartment, away from sources of moisture and heat.

The alarm system main unit includes a built in shock sensor, so the fitting position of the main unit should be

chosen to provide maximal efficient of the shock sensor operation.

2. The RF Base Station with antenna is to be mounted on the windscreen as high as possible to reach maximal

communication range between transceiver and vehicle.

3. The siren is installed in the engine compartment or in another location inaccessible for a thief, with the megaphone

down or sideward. The location must be away from heat sources and protected from penetration of water. If

the siren has a back up battery, access to the service keyhole must be ensured.

4. The pin switches of the hood and trunk are mounted in locations protected from water and inaccessible when

the hood/trunk is closed.

5. All high power circuits should be fused for respective currents.

Kit Contents

Voltage

Current Consumption

RF Frequency

Working Temperature

Maximal Allowable Current via the Relay Contacts:

Immobiliser Relay

Indicators Relay

Central Door Lock Relays

System Programming

Remote Code Learning

The AME MM 1 has two transmitters in the standard kit, however the system can teach up to four transmitters

To increase a number of remote controls to control the alarm system fulfill the below procedure:

1. When the alarm system is disarmed enter the PIN Code:

a. Within 7 seconds switch the ignition on/off twice and then switch it on again.

b. The LED will be flashing quickly. After quick flashing the LED will flash in a rate of one flash per second.

c. Count a number of flashes equal to your PIN Code and switch the ignition off.

d. If the PIN Code is correct the alarm system with double beep will confirm the Remote Code learning entered.

2. Press button 1 of each remote control you want to program to the system. One siren beep will confirm the

transmitter code is learnt. When you are programming a two way transmitter please wait a few seconds after

9...15V

20 mA

433,92 MHz

40...+85

20A

10A

15A

AME MM 2 Car Alarm System

Installation manual