ACR STOVES VitaMax Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Духовка. ACR STOVES VitaMax. ACR STOVES VitaMax 12 сторінок. Outdoor oven range

Друкувати сторінку

Vita

Remove all of the parts from the crate

■

and all of the parts that are contained

within the pizza oven dome.

It may be easier to put the pizza dome

■

on it's back for this part, place a blanket

down first, just make sure that the dome

is nice and stable and that you aren't

damaging any of the nice paintwork.

Locate the rear leg, it's the one with the

■

wheel attached, there are two rear legs

make sure that the correct leg is fitted

to the correct side! The wheel should be

on the inside of the leg, facing towards

the front of the oven.

Align the rear leg on the inside of the

■

metal pizza dome frame, line up the

holes and connect using four M5 x

12mm screws and the four M5 nuts,

tighten using a suitable screwdriver and

an 8mm spanner.

Next connect the other rear leg in the

■

same manner as above.

Position the storage shelf between the

■

two rear legs, line up the holes and

attach using one M5 x 12mm screw per

leg.

Position the front leg on the inside of

■

the metal pizza dome frame, line up the

holes and connect using four M5 x

12mm screws and the four M5 nuts,

tighten using a suitable screwdriver and

an 8mm spanner.

Next connect the other front leg in the

■

same manner as above.

Line up the holes in the storage shelf

■

and attach using one M5 x 12mm screw

per leg.

Sit the pizza oven dome on it's legs, be

■

careful it's heavy! Don't forget to use a

friend.

Check that the legs are square to the

■

pizza dome, check and retighten any of

the screws and nuts as necessary.

Slide the preparation shelves onto the

■

two hooks located on the left and right

of the pizza dome body and firmly push

into place.

la Madre

Attach the chimney base starter section

■

to the corresponding flue hole on the

top of the pizza dome, secure the

square base plate to the dome using

the four M5 x 12mm screws provided.

Slip the chimney top section over the

■

starter section and make sure that it's

fully located down.

Replace the insulating firebricks (the

■

lightweight ones) as shown below:

Vermiculite insulating firebricks

• 1 x (25 x 150 x 520mm) No1

• 1 x (25 x 120 x 520mm) No2

• 1 x (25 x 108 x 520mm) No3

Replace the chamotte firebricks (the

■

heavy ones) on top of the insulating

firebricks, as shown below:

Chamotte firebricks

• 4 x (30 x 200 x 266mm) No1

• 2 x (30 x 191 x 266mm) No2

Place your Vita oven onto a suitable,

■

level surface, a sufficient distance away

from anything flammable, as detailed

above.

Place the pizza dome door onto the

■

front shelf.

■

Let's get cooking!!