ACR STOVES E1200 Посібник із швидкого старту - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Діапазони ACR STOVES E1200. ACR STOVES E1200 9 сторінок. Electric fireplace insert range

Друкувати сторінку

Installation Instructions

This appliance must be installed by a competent person.

• The appliance must have a minimum

clearance of 50mm to combustible material

on the left and right sides of the appliance.

• This appliance is for indoor use only. It is not

designed to be installed outside. The

appliance must be kept away from any

source of damp or moist conditions. Avoid

any close contact with water.

• The appliance must be connected to a single

phase AC supply of the voltage specified on

the rating plate.

• If the appliance is being connected directly to

the mains electricity supply, a fused switched

Electrical Work

• This product comes complete with a UK 3 pin

plug. If the plug is removed for any reason, it

must be wired into an earthed power source.

Any alterations to the cable or power supply

must be carried out by a competent person.

• If the mains socket is to be concealed this

can be sited adjacent to the back of the

appliance, but must be easily accessible.

• Should the appliance be wired directly into

the mains supply a double pole switch fused

spur with a 13 amp fuse must be fitted. It is

imperative that the power supply is capable

of handling a load of 2000 watts (2kw).

• If the power cable is damaged in any way it

MUST be replaced by a competent person.

Location

spur with a 13 amp fuse must be fitted. The

power supply must be able to handle 2000w

(2Kw)

• The appliance must be earthed

• Not to be used in conjunction with either an

extension lead or a timer.

• All electrical work must comply with current

building regulations and electrical codes of

practice.

• If there is any doubt about the suitability of

the installation site contact your supplier.

• Do not connect the appliance to an extension

lead.

• The appliance must not be modified from the

manufacturer's specification in any way and

the appliance must only be used for the

purpose recommended by the manufacturer.

• If the appliance shows any signs of damage it

is important that it is examined by a qualified

person.

• Failure to observe these instructions may

result in electric shock or other serious injury.

• Check the technical specification.

Unpacking Instructions

Thank you for purchasing an ACR Fireplace Insert.

Please take a few moments to read through the following steps to enable your insert

to be unpacked without causing any damage to yourself or your new fireplace.

• Place the carton on a clean, flat surface and

ensure that you have sufficient space to work.

• Remove any rings, watches or bracelets

which could scratch the product or could

themselves be damaged during the

unpacking process.

• Carefully lift the appliance from the carton

and place the packaging to one side – do not

destroy the packaging as this may be

required for future transportation. Please

Optional Side Panels for the E1200

model

When unpacked, the E1200 model has only

one pane of glass visible at the front. Each

side section is covered with a blanking plate.

If the E1200 is to be installed as a two or three

sided appliance you will need to remove the

plate / plates. To achieve this, remove the

screws from the frame on the body of the

insert, remove the blanking plate and then refit

the frame to the body and secure in place with

the screws.

ensure that plastic bags are kept away from

children and animals.

• Plug the appliance into the mains to check it

is working prior to carrying out the

installation.

• Follow the instructions on the body of the

appliance to remove the pack from inside.

This appliance is designed for use ONLY as

described in this manual. Any other use

could lead to bodily harm and / or fire.