Coalbrookdale GS1i Інструкція з монтажу та обслуговування - Сторінка 14
Переглянути онлайн або завантажити pdf Інструкція з монтажу та обслуговування для Піч Coalbrookdale GS1i. Coalbrookdale GS1i 19 сторінок.
REPLACEMENT OF PARTS
Ensure the stove is cold.
Isolate the gas supply to the stove.
On completion ALWAYS check for gas soundness.
Hands should be washed after handling coals. (If gloves
are not used).
Open the door of the stove (using the tool supplied).
Disconnect gas supply to Control Valve.
Remove coals and coal guard (See Fig. 20).
Remove the Burner Assembly Tray Location and Securing
Screw (See Fig. 20).
Carefully lift out the burner assembly tray and retain the
clay aggregate. If necessary top up the tray with clay
aggregate during re-assembly as described in 'LAYING
THE FUEL BED'.
The following components can now be replaced, as
follows:
Gas Valve
Disconnect the thermocouple, the injector and pilot feed
pipes at the gas valve.
Disconnect the ignition lead at the tap.
Pull off the control knob and remove the gas valve (2
screws).
Fit replacement valve and re-assemble in reverse order,
carefully replace the coals as described in 'LAYING THE
FUEL BED'.
CHECK THE BURNER PRESSURE AS DESCRIBED IN
'TO LIGHT THE STOVE'.
Main Burner Injector
Disconnect the feed pipe at the main injector and remove
injector.
Fit replacement injector and re-assemble in reverse order,
carefully replace the coals as described in 'LAYING THE
FUEL BED'.
Pilot Assembly
Disconnect the feed pipe at the pilot assembly.
Disconnect the thermocouple connection at the control
valve and pull off the ignition lead from the electrode.
Remove the pilot assembly (one nut).
Fit the replacement pilot assembly and re-assemble in
reverse order.
NOTE: Ensure that the insulation sleeving is pushed back
over the end of the electrode during re-assembly.
Carefully replace the coals as described in 'LAYING THE
FUEL BED'.
13