aero pure ABF110DHG5 Series Інструкція з монтажу Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Вентилятор aero pure ABF110DHG5 Series. aero pure ABF110DHG5 Series 15 сторінок. Bath fan
Також для aero pure ABF110DHG5 Series: Інструкція з монтажу Посібник з монтажу (15 сторінок), Інструкція з монтажу Посібник з монтажу (15 сторінок)

PLUG-IN DEVICES

Humidity(RH%)

INSTALLATION PLUG-IN DEVICES

Humidity Sensor Module or Motion Sensor Module is included with this fan.

Contact Aero Pure to purchase CO2 Sensor Module.

Position A is for CO

and position C is for Motion Sensor module.

1. Fix to the specified devices to the slot, till hear the sound installed in place.

2. Access USB interface, insert the connector of module into USB receptacle.

Notes:

Suitable for use with solid-state speed controls.

Solid-state speed controls may cause harmonic

distortion which can cause motor humming noise.

Humidity Sensor Module- Included in this Aero Pure fan. Insert module

into USB interface. The fan automatically turns on or boosts to a higher

speed when the Relative Humidity (RH) exceeds the user-adjustable

set-point. The fan automatically runs in a lower speed after a period of

time delay or stops running when the Relative Humidity falls below the

set-point.

Humidity detection value setting range: 30% - 80%

Motion Sensor Module- Insert model into USB interface. The fan runs

or boosts to high speed when motion sensor begins to detect.

The fan runs in low speed after a period of time delay or stops working

when you are out of detection range.

Motion Sensor detection range as below,

CO2 Sensor Module- Insert module into USB interface. The module

begins to detect environmental CO2 concentration when fan is on for

2 minutes, then the fan starts to run or boosts to high speed when

concentration level is over 1000PPM. The fan runs in low speed after

a period of time delay or stops working when concentration level

is less than 800PPM.

Sensor module, position B is for Humidity Sensor module,

USB receptacle

The distance that motion can be

detected is limited to 10 feet (3m).

The field of view of the sensor is

90°. (Room temperature is 25℃).