Acer AC707 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Монітор Acer AC707. Acer AC707 22 сторінки. Acer ac707: user guide

Друкувати сторінку

INSTALL THE

MONITOR

• To connect the tilt/swivel base to the monitor, align

hooks with the sockets on bottom side of the

monitor, and gently push the base towards the front

of the monitor.

• The 15-pin D-shell signal connector on the signal

cable will connect easily to the video adapter

output on your personal computer. Lock both

screws on the connector to ensure a firm

connection.

• Turn the PC power switch ON. Then turn the

monitor power switch ON, by pressing the switch

inward. The green power indicator will light up.

• Allow about 30 seconds for the CRT tube to warm

up. Data will be displayed on the screen.

• If your display fails to function properly, please

first refer to the section "Troubleshooting" in this

manual.

POWER CORD

•

Check first to make sure that the power cord you

use is the correct type required for your area.

•

This monitor has a universal power supply that

allows operation in either 100/120V AC or 220/

240V AC voltage area. No user-adjustment is re-

quired.

•

First connect the power cord into your monitor's

power input socket, and then plug the other end

into a 3-pin AC outlet. The power cord may be

connected to either a wall socket or the power out-

put socket on your PC, depending on the type of

power cord supplied with your monitor.

•

For units to be used at 120V AC:

Use a UL Listed Cord Set consisting of a min.

No. 18 AWG, Type SVT or SJT three-conductor

a maximum of 10 ft. in length and a parallel blade,

grounding type attachment plug rated 10A, 125V.

•

For units to be used at 240V AC (domestic use):

Use a UL Listed Cord Set consisting of a min. No.

18 AWG, Type SVT or SJT three-conductor cord

a maximum of 10 ft. in length and a tandem blade,

grounding type attachment plug rated 10A, 250V.

•

For units to be used at 220/240V AC (outside of

U.S.):

Use a Cord Set consisting of a min.

0.75mm

,3G,Type H05VV-F cord and grounding

type attachment plug rated 16A, 250V. The cord

set should have the appropriate safety approvals

for the country in which the equipment will be

installed and marked HAR.

English

E-3