10Bar Underwater Housing Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари для фотоапаратів 10Bar Underwater Housing. 10Bar Underwater Housing 16 сторінок. Underwater housing for olympus e-pl2
Також для 10Bar Underwater Housing: Посібник користувача (15 сторінок)

Друкувати сторінку

Note: If the O-ring has formed a good seal, a continuous thin black line, about 0.5 to 1mm in width

should be visible where the O-ring is in contact with the lid. Follow this line all the way round the lid

as a final check that the seal is good.

Maintaining the O-rings

The O-ring is the main seal in keeping sea water out of the housing. It is an effective barrier only if the

O-ring is properly maintained. The O-ring should be inspected before every dive. The following

information is provided for your guidance in using and maintaining the O-ring.

There are two O-rings, one on the lid and one on the housing, which require regular maintenance.

Remove the O-rings periodically for inspection.

It is not necessary to remove, clean and re-install the O-rings after every dive provided the O-rings are

not contaminated.

If the housing is to be opened between dives for changing memory card or re-charging battery, make sure

the outside of the housing is thoroughly towel dried before opening.

After servicing the camera, replace the lid right away.

Before replacing the lid, check the O-rings and O-ring recesses, making sure that no contaminants such

as dust, hair, salt, sand etc., has fallen onto them.

The O-rings should be inspected every time the lid is opened and maintenance carried out only if

necessary.