Aktakom AM-1016 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Мультиметр Aktakom AM-1016. Aktakom AM-1016 12 сторінок. Network multimeter

The Network Cable Tester will check a fault condition in the above descending order before detecting

other fault conditions. The detection and indication of the presence of a fault is handled on a. "one-per-

test" basis. Once a fault is corrected, it is recommended the cable be tested again for other faults.

OPEN There is no "OPEN" indication. A typical cable may have 2, 3, or 4 pairs. OPENS are displayed as an

unlit symbol. The user will determine if a pair is present and continuous or OPEN by comparing the

illuminated symbol to the expected number of pairs that should be good.

SHO.

A short circuit condition exists (see Fig.1).

MIS.

Indicates the improper assignment of individual wire pairs to pins for the wiring schemes tested

(see Fig.2).

REV.

Reverse wiring means the pin for one wire in a pair is connected to the opposite pin for the pair

in the remote jack (see Fig.3).

SPL.

Split pairs occur when the tip (positive conductor) and ring (negative conductor) of two twisted

pairs are interchanged (see Fig.4).