Aktiv X7 Comfort Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Інвалідний візок Aktiv X7 Comfort. Aktiv X7 Comfort 9 сторінок.

Safety recommendations

1. The maximum capacity for this wheelchair is for 150kg. Users over 150kg, please use carefully.

2. For self propel wheelchairs, the user should maintain an uniform speed. The recommended speed

for self propel use is at 3-5Km/h.

3. The wheelchair is recommended to be used on flat ground. If any obstacle appears, please detour

to avoid any danger of topple and fall.

4. While using the wheelchair, the user should not stand on the footrest as this act will cause danger

of topple and fall.

5. The user must assure to have good body condition before using the wheelchair on sloping

ground. The angle of the sloping ground should be no more than 10 degrees for safety

considerations. If the angle of the sloping ground is over than 10 degrees, there must be an

attendant to assist the user to push the wheelchair at the back.

6. Do not tilt or swerve while the wheelchair is being used on sloping ground. Using brakes abruptly

when going downhill is not recommended as this will cause danger of topple and fall to the front.

To keep the wheelchair in its best condition, please proceed with the following maintenance:

1. Before using the wheelchair and during the first month of use, check all the screws if they are

tightened. If any loosen situation appears, please tighten immediately to assure the safety of the

user. Under normal use, please proceed with routine inspection every 3 months to assure all the

parts are in good condition, to check all the screws and nuts are tightened (specially the fixing nuts

of rear wheels and the brake system). If any loosen situation occurs, please adjust and tightened in

time.

2. The wheelchair must be dried after using if it gets wet in rainy days. Under normal use, the

wheelchair must be cleaned often with soft cloth and applied the anti-rust wax to maintain the good

condition of this product.

3. Maintain the frame clean and dry under dry and ventilated place to avoid any rust on the parts.

4. Check often the agility of rotating parts and add little lubricants regularly.

5. Avoid any oil or acid contacts with the wheels to prevent deterioration and maintain the adequate

tire pressure (when using pneumatic tires).

6. The leather used on seat, backrest, shoulder stopper, hip stopper, armrest side boards and

headrest can all be removed to cleaning and sterilized purposes.

Mobility, Comfort and Style.