Aktobis WDH-BGP03 Посібник із швидкого старту - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Обігрівач Aktobis WDH-BGP03. Aktobis WDH-BGP03 8 сторінок.

1.3 Now set the desired temperature switch-off point (0 ~ 45°C) with the stepless

thermostat control dial (right-hand knob). This is best done as follows: Turn the

thermostat knob to the highest temperature (MAX.) and let the heater run until

your desired temperature value is reached. Now turn (adjust) the control

downwards towards the minimum until the heating function switches off

automatically. Now let the control dial

(thermostat) on this position and whenever it gets colder in the room, the unit

automatically starts heating and when the adjusted temperature is then reached

again, the unit automatically switches off again !!!

Switch off

To switch off the unit, turn the stepless thermostat control knob (right-hand knob) to

minimum (MIN) and let the unit run in fan mode for about 5 minutes to allow it to cool

down. Afterwards, also turn the operating strength adjustment knob to "0" to switch off

the unit completely.

Cleaning & Storage

Always unplug the heater from the mains and allow it to cool down completely before

cleaning it !

3.1 Cleaning the housing:

Use a soft and damp cloth to clean the outside of the housing.

Only use mild cleaning agents to clean your heater.

Also, make sure that no aggressive cleaning agents are used, as these can

damage your appliance !

Please make sure that no water gets inside your heater at any time !

3.2 Storage:

We recommend that you repack the unit in its original box for storage.

Store the heater in a dry and sufficiently ventilated place/space.