American Rotary AMP series Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа American Rotary AMP series. American Rotary AMP series 6 сторінок. Phase converter

Друкувати сторінку

INTRODUCTION

American Rotary specializes in converting single phase electrical power to three phase

electrical power. The three-phase output is delta configured. Most machinery requires a

delta three phase voltage and this third line voltage to ground should not affect operation.

If a piece of equipment requires wye voltage and a neutral connection, the output of the

phase converter must be run through a delta-wye transformer to create the neutral. The

phase converter must be started before the transformer is connected electrically. This is

done with a safety disconnect switch. American Rotary can provide these transformers

and disconnect switches if needed by calling 888-743-6832.

INSTALLATION

Your AMP phase converter from American Rotary has been designed to be completely

plug and play for your convenience. The AMP has come equipped with the necessary

components for easy connection and set-up (installed features may vary).

STEP ONE:

To connect to your single phase power supply, use the provided Nema 6-50P single

phase plug (Customer requires a 208v-240v Nema 6-50R three prong single phase

female receptacle).

STEP TWO:

Connect the three phase load using the pre-installed three phase receptacle. If you do

not have a male connector plug for this, you can purchase them at American Rotary by

calling 888-743-6832.

STEP THREE: Turn on the AMP rotary converter by pressing the green START button

located on the front of your converter. This is a magnetic starter intended to start the

rotary phase converter. It is not designed or intended to be able to start your load. If

you do not have a motor starter for the intended load, one can be purchased through

American Rotary by calling 888-743-6832. To turn off the converter, use the red button

labeled STOP also located on the front of the panel. See STARTING AND STOPPING on

page 5 for more information.

STEP FOUR: Place your pre-installed breaker to the on or up position. This breaker is

located above the installed receptacle.

STEP FIVE: Turn on the power to your load and enjoy having quality three phase power

at your fingertips.