American Standard 4175.300 Series Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Сантехнічний виріб American Standard 4175.300 Series. American Standard 4175.300 Series 3 сторінки. Single control kitchen pull-down faucet
Друкувати сторінку2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly
to wall supplies. Connection on fitting
supplies are 3/8" compression. Connect
left supply (Marked with a Red Stripe) to Hot
and right supply (Marked with Blue Stripe) to
Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 21" long from faucet base.
Note: If additional supply length is
required, installer must purchase
additional parts separately.
Important: If SUPPLY HOSES (1, 2) are
too long, loop as illustrated to avoid kinking.
3
INSTALL WEIGHTS
With HAND SPRAY (1) seated in SPOUT (2),
install two sets of WEIGHTS (4) onto HOSE (3)
using two SCREWS (5). Locate the WEIGHTS (4)
16 inches from the underside of the sink deck.
Tighten SCREWS (5) firmly.
4
TEST INSTALLED FAUCET
Move HANDLE (1) into "off"
position.
Turn on water supplies.
Check connections for leaks.
(See Section 5)
2
3
REMOVE
With HANDLE (1) in "off" position,
unthread SPRAY (3) from HOSE (2).
Operate handle back to front, in COLD
and HOT positions, to flush water lines
thoroughly.
Replace SPRAY (3) onto HOSE (2).
SPRAY OPERATION
With FAUCET on press TOGGLE BUTTON (4) on SPRAY (3) to
switch from stream to spray.
Press and hold PAUSE BUTTON (5) to temporarily stop flow from
SPRAY (3). Release PAUSE BUTTON (5) to resume flow from
SPRAY (3).
1
1
HOT
2
1
16"
4
3
STREAM (AERATOR)
3
SPRAY
2
COLD
5
5
4
M 9 6 5 0 3 6 R ev 1. 2