BobsCNC KL733 Посібник для початківців - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник для початківців для Принтер BobsCNC KL733. BobsCNC KL733 9 сторінок. X frame assembly
Також для BobsCNC KL733: Посібник (18 сторінок), Посібник з монтажу (12 сторінок), Збірка (20 сторінок)
Друкувати сторінку
Assembly Area Requirements:
A large, clean, well lit bench top is needed. The Optional Table for the
KL 733 was specifically designed to provide an adequate assembly
surface area (48" x 44").
Two separate 110 vac 20 amp circuits for the Controller and 48 vdc
Power Supplies, and the dust collection system are also needed.
Sealing the Wood Component Prep:
The KL series CNC Routers feature 12 mm Baltic Birch plywood. Baltic
Birch is manufactured using exterior grade adhesives, however, as a
best practice we recommend that customers seal the outer birch veneer
surface and all edges with polyurethane. Seal every wood component
with two coats of polyurethane applied according to the manufacturer's
directions.
The double-sided tape used to affix the static drive belts of the Bell
Everman Drive System to the Belt Supports has been specifically
designed by 3M to adhere to a polyurethaned surface.
The tab and slots in the kit have been engineered for a tight fit. You
may find it easier to assemble the wood components before sealing
with polyurethane.
Solvent (oil) based polyurethane should only be used in work areas with
adequate ventilation. BobsCNC has tested water-based acrylic poly
with acceptable results (water based poly has significantly lower VOCs
and a faster drying/curing time).
8