BarMaid BLE-310 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Блендер BarMaid BLE-310. BarMaid BLE-310 9 сторінок. 3hp commercial blender

CLEANING INSTRUCTIONS

The BLE-310 blender container parts are corrosion resistant, sanitary

and easily cleaned. Do not put the container assembly or blender base

assembly in the dishwasher.

1. Before first use and after every use, separate container from the base.

2. To clean the container: Use a washing solution of tepid water (less than 115°F/46°C)

and a non-sudsing detergent.

3. Scrub and flush out the container interior lid and feeder cap to remove food residue.

Empty container.

4. Fill container 1/4 full with fresh washing solution and place it on the base.

5. Replace the lid and feeder cap on the container and run the blender on high speed

for 2 minutes.

6. Repeat step 4 using clean rinse water (95°F/35°C).

7. Wipe down the outside of container, feeder cap, and lid with a soft cloth or sponge,

dampened with fresh washing solution.

8. Wipe the exterior of the base with a damp cloth or sponge. The base contains

electrical components: do not immerse. use a high-pressure washer, or use a

dishwasher to clean the base.

BLENDER CARE

1. Periodically check all parts before reassembly. Use of damaged or non-recommended

parts could result in severe personal injury and/or damage to the blender.

2. Blades:

If the processing blades are stuck or difficult to turn. DO NOT USE BLENDER.

Remove container from the base. Check by carefully turning the blades in a counter-

clockwise direction, where the opposite edges are sharp. Blades should turn freely.

If not. call for service or replace container.

3. Container:

If the EASTMAN TRITAN container is cracked, DO NOT USE BLENDER, further use

could result in the container breakage during use.

4. Blender Base:

Never immerse the blender base in water. To clean, unplug base and use a damp

cloth.

5. Motor:

The motor is permanently lubricated and does not require any additional lubrication.