BobsCNC E3 Посібник з усунення несправностей - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Електроінструмент BobsCNC E3. BobsCNC E3 16 сторінок. Cnc router engraver bearing and rail dust kit
Також для BobsCNC E3: Посібник (8 сторінок), Посібник із швидкого старту (3 сторінок)
Друкувати сторінку
- 1. Table of Contents
- 2. My Stepper Motors Are Running Backward
- 3. My Z Axis Is Not Homing Correctly
- 4. My E3 will Not Home Correctly (Diagnosing Home Switches)
- 5. My Firmware Does Not Seem to be Working
- 6. I Tried to Use Easel, Now My Machine Does Not Work Correctly
- 7. I Get and Error When I Run a G-Code File Made with F-Engrave
- 8. My Z Stepper Motor Wobbles Excessively
- 9. My Machine Seems to be Skipping some Commands
- 10. What Are the Alarm Code Descriptions
- 11. How Do I Change My Current Setting on the Stepper Motor Drivers
- 11. Setting the Current on the A4899 Stepper Motor Driver with a Volt Meter
- 11. Setting the Current on the A4899 Stepper Motor Driver Without a Volt Meter
- 12. The Dewalt Motor Shaft Came out During Assembly. (Dewalt Brush Remove and Replace)
How do I change my current setting on the stepper motor drivers?
There are 2 styles of stepper drivers that we have for the E3. Both styles work equally well, but the
current needs to be set with different values. The yellow circles denote the driver with the R200
resistors. The blue circles are the R050 resistors. Note that these resistors are in different locations.