Canon AE-1 Посібник з інсталяції Посібник з інсталяції - Сторінка 46

Переглянути онлайн або завантажити pdf Посібник з інсталяції Посібник з інсталяції для Цифрова камера Canon AE-1. Canon AE-1 48 сторінок.
Також для Canon AE-1: Початок роботи (2 сторінок), Інструкція з експлуатації (22 сторінок), Посібник (42 сторінок), Посібник (12 сторінок), Інструкція з експлуатації (22 сторінок)

Adjusting the Tilt

1) Loosen the two fixing screws [I] each on the front

and rear casters on the delivery side of the finisher.

2) To decrease the gap between the punch unit and the

host machine,

turn

the adjusting bolt [2] in the di-

rection of the arrow A (A full turn of the adjusting

bolt will increase the height of the finisher by 1.75

mrn.). Refer to the index on the caster while turning

the bolt, and perform this for both front and rear

casters.

3) To increase the gap between the puncher unit and

the host machine, turn the adjusting bolt [2] in the

direction of the arrow B (A full

turn

of the adjusting

bolt will decrease the height of the finisher by 1.75

mm.). Refer to the index on the caster while turning

the bolt, and perform this for both front and rear

casters.

Making Checks after Adjustment

1) Check to see once again the that the difference in

height between the finisher and the puncher unit

and the tilt are as indicated; If not as indicated, start

over the adjustment work.

2) When done, tighten the two fixing screws [ l ] each

on the casters.

3) To prevent the adjusting bolts from becoming loose

during transit for possible relocation aAer installa-

tion, tighten the bolts [2] 90 deg in the direction of

the arrow. Take care, however; excess tightening

will affect the heighthilt.

4) Attach the spanners to the back of the front cover

using a screw.

5) End the installation work as instructed in "Installa-

tion after Checks/Adjustments" and later.